Remote SDR V5 -Raspberry 4B or Orange Pi Image Installation
Here is the detailed procedure to install Remote SDR in version 5, on a Raspberry Pi 4B with at least 2 GB of memory or an Orange Pi Zero 2. The latest images written...
Ham Radio - Radioamateur - Domotique
Here is the detailed procedure to install Remote SDR in version 5, on a Raspberry Pi 4B with at least 2 GB of memory or an Orange Pi Zero 2. The latest images written...
GNU RADIO 3.9 – Osmocom – Soapy SDR RTL-SDR – HackRF – Adalm-Pluto – RSP1 – RSP1A – SA818 Below is the detailed procedure for installing Remote SDR in version 5 on a Raspberry...
Web based Transceiver “Remote SDR” is a web application allowing to remotely control an amateur radio transceiver between 1 MHz and 6 GHZ. Its first application was the duplex control of a station allowing...
With a system (Remote SDR) running remotely 24 hours a day, we are not immune to a system crash and especially a loss of remote control. To remedy this, it is possible to set...
For those who would like to open ports to communicate with the outside world, since version 5 of Remote SDR, all communications (audio, video, parameters) are done in https on port 443. This is...
It is possible to set the GPIO outputs according to the reception or transmission frequency. This is applicable for configurations with one or two orange PIs. This makes it possible to switch relays, for...
With intense use, the CPU may heat up, especially if it is mounted without a heat sink. If 65 ° C is exceeded,one GPIO pin goes to 1 to control the power on of...
COMPACT CONFIGURATION with an ADALM-PLUTO – Rasperry Pi 4 – ETHERNET Avantages Disadvantages – Well-known RPI4 – Wifi or Ethernet– 12 bits of Pluto dynamic – poor stability in frequency of the Adalm-Pluto May...
Recent Comments