Remote SDR v2 – Tips

Launch of Remote SDR

In the address bar of Chrome or Edge, enter the IP address of the Orange Pi or one of the 2 Orange Pi if you have a dual configuration. If the system asks you, give the IP address of the orange PI of the receiver and the address of the transmitter. Put the same for a Pluto.

Go to the Remote SDR page. The ‘RX On’ indicator is red then should turn green after a few seconds, then the same for the ‘TX On’ indicator.

If one of the LEDs remains red, reload the page.

The Spectra green line should fill with a vertical line 5 times per second. This corresponds to the arrival of a spectrum frame (2048 values at the output of the FFT).

In some rare cases, the received spectrum is reversed. It must come from complex demodulation oscillators that do not start on the correct phase. Do a ‘Relaunch’ and it is fine.

Starting the Adalm Pluto

In the ‘Tools’ page there are 2 tools to check if the Pluto responds. Sometimes it gets stuck, a reboot may be necessary. The ‘help’ command gives a list of commands that can be sent to Pluto. It’s irrelevant, but it shows that it is reacting correctly.

In principle you need a USB hub between the Pluto and the Orange PI. This corresponds to a system bug that I cannot explain.

Starting RTL-SDR

In the Tools page, we have a tool for obtaining RTL-SDR info. This makes it possible to verify that it is responding. Be careful, some models heat up and no longer respond after a certain time.

Starting HackRF One

In the Tools page, we have a tool to obtain Hack-RF info. This makes it possible to verify that it is responding.

Frequency drift compensation

In case of traffic via QO-100, it is necessary to compensate for the drift of the LNB in the antenna. Remote SDR makes it possible to track the high and low beacons in frequency and estimate the compensation to be made. Each time Remote SDR is launched, check the beacon setting and manually compensate if necessary by turning the mouse wheel on the numbers. Then the automatic compensation will do what is necessary.

Adjusting Frequencies

For fine adjustment of the frequency of the receiver, the transmitter, the compensation of the receiver or the transmitter, there are different means:

  • turn the mouse wheel on the numbers
  • click on the figures to display a zoom and then turn the mouse wheel or slide your finger above the figures.

RX and TX Gains Adjustment

Depending on the SDR model, the gains are different and some of the sliders are not used. Experiment to find the optimum corresponding to your configuration.

Dynamic spectra tuning

For the ‘Waterfall’ and the trace in amplitude of the spectrum, click on the arrow on the right to adjust the sliders. The setting is different for each SDR.