Andre,
I have discovered GPIOS are settable on the Settings page of Remote SDR. Wasn't that so intuitive for me but after checking your YouTube videos I have understood where and how to configure.
Regarding GPIO that should be turning on a relay delivering power to the PA do I understand it correct that this one is not settable in Settings under GPIO section either in Rx Configuration or Tx Configuration? As written in both sections "NumGPIO 7 or pin 26 reserved for Transmit security Oscillator" meaning it can't be used because this is the one toggling automatically on every 256B of received audio data?
Thanks for confirmation.
I have discovered GPIOS are settable on the Settings page of Remote SDR. Wasn't that so intuitive for me but after checking your YouTube videos I have understood where and how to configure.
Regarding GPIO that should be turning on a relay delivering power to the PA do I understand it correct that this one is not settable in Settings under GPIO section either in Rx Configuration or Tx Configuration? As written in both sections "NumGPIO 7 or pin 26 reserved for Transmit security Oscillator" meaning it can't be used because this is the one toggling automatically on every 256B of received audio data?
Thanks for confirmation.
Grzegorz SP6HFE