Remote SDR for EME

[Jorge EA2LU]

Hi to all,
I´m building a remote control 23cm EME station. The place of my 3m dish are 15km away from home QTH with no obstacles direct patch.
5Ghz Ubiquiti airOS5 give me the network connection and Raspberry Pi3 and Pi4 + Arduino hardware doing all the jobs in remote place.
I found perfect for my purposes, Andre F1ATB Remote SDR tool, that I configured to use with SDRplay RSP1a for RX and HackRFone for TX side...
I´m now setting up the Raspberry pi4 with Remote SDR, I wonder wath is the best way to run WSJT-x and Remote SDR together ?
As there aren´t "virtual audio cables" for Linux, have to use ALSA + PULSE to managing audio in outs??
Anybody have experienced on this matter? Any comments are welcome.
Thank you very much in advance.
Jorge 
EA2LU
Loc IN92dt 
Attached photo of the dish and the box where the full setup will be allowed.

[F1ATB]

Here some explanations
https://f1atb.fr/wsjt-x-ft8-2/
André / F1ATB

[Jorge EA2LU]

Thank you very much Andre for your quick answer!
Yes, sometime ago, I was reading those explanations for W10 users, as all machines in remote place are Raspberry pi
It is dificult to adapt same solution.
But, thank to your answer, I`m thinking to use the WSJT-X here at home in a Windows enviroment, getting the audio
from Remote SDR software....
I will do some test with audio choices and results...
Definetely, I don´t like to use Pulse+ Alsa and "NoMachine" combination...
Your solution seems to be more stable, and easy to setting up..
Will keep informed of my doubts too!
Tank you and have good week start..
Jorge
EA2LU