WSJT-X – FT8
Remote SDR can be interfaced with digital processing software like WSJT-X to make FT8 transmissions for example. WSJT-X not only processes transmit and receive audio signals, but can control Remote-SDR frequency and transmit on/off....
Category: Remote SDR
Omnirig – Remote SDR
Omnirig is an interfacing application to control different transceivers by a third party application like (YONIQ-SSTV, WSJT-X…) . It controls, for example, the transition to transmission or the reception frequency. Architecture Many amateur radio...
Communication Ports
For those who would like to open ports to communicate with the outside world, since version 5 of Remote SDR, all communications (audio, video, parameters) are done in https on port 443. This is...
Tone generators
On the transmit side, different tone generators are available to tune the transmitter or open relays. 800Hz Tone Selecting this generator disconnects the microphone and injects a 800Hz audio signal to its maximum. This...
Setting of GPIO outputs
It is possible to set the GPIO outputs according to the reception or transmission frequency. This is applicable for configurations with one or two orange PIs. This makes it possible to switch relays, for...
Band Scanning
It is possible to define one or more scanning zones of the reception band. The system automatically locks onto the correspondent and changes it every 10 seconds. With the mouse, it is possible to...
Gains and Dynamics
RX and TX Gains Adjustment Depending on the SDR model, the gains are different and some of the sliders are not used. Experiment to find the optimum corresponding to your configuration. The dynamics of...
Frequencies Management
The video below presents the management of frequencies, drifts of the receiver and the transmitter. In the second part, we review the filling of the parameters of Remote SDR in the “Settings” page. Frequency...
Recent Comments